Formation of two phases inside the same can of product.
Posible causes
Dilution with an inappropriate solvent.
Over dilution of the product.
Contamination of the product.
Solution
Follow the recommendations related to dilution of the product.
Avoid using solvent for dilution different from mineral spirit.
Use tools in good condition for stir the product.
Avoid storing the products by prolonged intervals of time.
If the separation is light, stir the product with the aid of a clean spatula.
If you are going to use thinner, make sure it is high quality. Some thinners have very strong solvent organic or have a high degree of water, which not only generate the problem of separation, but also problems of drying, shine or no wanted appearance of the film.
Description
Excessive increment of the viscosity of the product in storage.
Posible causes
Prolonged time of storage.
The product is exposed to high temperatures for prolonged time.
Solution
Store the product in a fresh and low temperature laces.
Rotate the product.
Description
Once the product is applied, appears a milky veil in the film.
Posibles causas
The temperature in the place during the application is under 10°C.
The humidity of the place during the application is above 90%.
The product is mixed with water or inappropriate solvents.
The film is cleaned often with water or very strong detergents.
Solution
Clean the film.
Apply a new coat of enamel; take into account the temperature and humidity of the place of application are favorable.
Check atmospheric conditions before painting.
Avoid the application of the product during rain.
Avoid the frequent cleaning of the product applied.
When the surface painted require cleaning, use non abrasive materials and cleaning agents.
Description
The paint film evokes in appearance the shell of orange, with non uniform leveling along the finish.
Posible causes
The product is applied on a very hot surface.
Tools of application in bad condition.
The pressure of air in the air sprayer tool is not the appropriate one.
Use of low quality or not recommended solvents.
Solutions
Let the paint to dry perfectly.
Sand and clean very well the surface.
Apply other coat of paint, diluting with mineral spirit of good quality.
Avoid painting on hot surfaces.
Follow the recommendations related to drying and retouch times.
Make sure the surface to paint is well prepared.
In case of application with air sprayer, make sure the pressure of application is the appropriate one.
