Follow the steps 1 to 3 as indicated in the section of installation of Venetian Recol® Plaster.

Detail the surface and eliminate imperfections following the recommendations of usage of Recol® Wax-Metallic with the spatula or trowel and apply on the surface with the technique of spatula, using Recol® Wax-Metallic in the direction and design as desired.

Allow the film of Recol® Wax-Metallic to dry partially and extend the excess to obtain a smooth finish.

Allow the surface to dry completely between three and four hours.

Shine once more by rubbing with force the edge of the spatula or trowel upon the waxed surface and pass again the surface with a clean and dry piece of cloth. In the sample presented the base was Venetian Recol® Plaster blanco and Recol® Wax silver.