Recol®’s Anticorrosive can be applied on any porous surface, whenever this surface is clean, dry, free of dust, dirt, grease, oxide, loose particles, contaminant agents and paint in bad condition.
In surfaces such as galvanized as well as not ferrous surfaces it is necessary to apply previously a primer like Wash Primer.
The solvent for dilution is mineral spirit.
brush, roller or conventional air sprayer.
Apply from one to three coats of Recol®’s Anticorrosive, maintaining the brush or roller with sufficient product to achieve a uniform finish.
Use natural bristles brushes for the application.
Dilute Recol®’s Anticorrosive with 10% of mineral spirit for application with roller and dilute with 5% of mineral spirit for application with brush.
Apply as much coats of Recol®’s Anticorrosive as you need, according to the performance required (thickness of film and hiding power desired).
Dilute Recol®’s Anticorrosive with 10% of mineral spirit and adjust the pressure of the equipment.
Time of drying:
Recommendations:
Allow a time to touch between 1 to 2 hours and a retouch time between 8 to 10 hours.
The time of dying depends on the atmospheric conditions of humidity and temperature.
Once you have finished the application of Recol®’s Anticorrosive and/or its mixtures, clean the tools used with mineral spirit or thinner.
Cover up the cans and/or its mixtures, ensuring they are hermetic.
To avoid the drying of Recol®’s Anticorrosive during its storage, put a small quantity of mineral spirit on the top of the liquid before cover up the cans.
When you use solvents or acids, make sure you use the appropriate personal protection equipment.
